Widener University, Chester, PA (1979)
Master of Science in Engineering Science (Safety Engineering and Human Factors) - New Jersey Institute of Technology (1997)
Non Degree Training:
• DuPont Explosives Handling and Safety Seminar
• RCRA Training Seminar - New Jersey Institute of Technology
• Forklift Instructor Training - National Safety Council
• Advanced Commercial Vehicle Accident Reconstruction -
Texas A&M and NTSB
• Advanced Traffic Accident Reconstruction
I.P.T.M., University of North Florida
• Automobile Fire Investigation - International Association of
Arson Investigators
• Anti-lock Brake Systems Seminar - Wagner Brake Products
• Accidental Injury: Biomechanics & Prevention -
University of California
• 43rd Annual Stapp Car Crash Conference, 1999
• 12th Annual Ergonomics Conference, University of NH, 2002
• Safety Management for the Construction Industry, University of NH
- New Hampshire - License #9823
US Patent #6,076,532 Hair Gathering Device
A.C.T.A.R. Accreditation - #1021
| Experience: |
Clutch and Gear Division
Machinery test procedure preparation.
Naval ship drive train proposal evaluation.
Structural steel design work.
Engineering Assistance for fleet repair and maintenance.
Thomas & Betts Corporation, Bridgewater, NJ
Research & Development Laboratory
Development of test programs for product and tool performance evaluation, durability and qualification.
Design and fabrication of electrical and mechanical test equipment.
General Cable Company, Edison, NJ
Research & Development Laboratory
Development of new products, equipment and processes.
Investigation of product failures and customer complaints.
Electrical and mechanical equipment and tooling design and development.
Product and material specification preparation.
Develop and train personnel.
General Motors Company, Linden, NJ
Tooling Department
Design, layout, installation and repair of automobile assembly equipment
and fixturing.
Supervisory capacity over tool makers.
Training of personnel in equipment use and repair.
Responsible for proper and accurate assembly of automobiles and
troubleshooting of assembly problems.
Thomas Engineering, Bridgewater, NJ
Building systems design and evaluation.
Residential home inspection.
Machinery, electromechanical component and systems design and
evaluation including control system design.
Site plan preparation.
Breed Automotive Corporation, Boonton, NJ
Held the positions of Sr. Manufacturing Engineer - Facility and Safety
Manager and Product Engineer.
Responsible for facility management, equipment design, layout and
installation, buildings construction and renovations including safety
engineering and environmental management.
Responsible for developing functional air bag crash sensor systems;
including sensor component design, crash performance analysis and
vehicle interface.
Affiliated Engineering Laboratories, Inc., Edison, NJ
Engineering Consultant
Machinery, tools, equipment and systems evaluation.
Safety and ergonomic assessment.
Laboratory and physical test analysis.
Equipment and product failure analysis.
Accident study and reconstruction.
Analytic Engineering
Engineering Consultant
Machinery, tools, equipment and systems evaluation.
Safety and ergonomic assessment.
Laboratory and physical test development and analysis.
Equipment and product failure analysis.
Accident assessment and reconstruction